VK204-25 ?

[kfaria]

Hello....

There may be an error in the manual:
VK204-25_rev_20.pdf
Unless I'm totally reading it wrong....
As it is the weakend, I do not have a unit in front of me to verify it.
Just looking over the code / manual and found a couple of anomalies.
Will triple check on Monday.

.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.

10.4 Set VFD Brightness
Decimal 254 89 [brightness]
where [brightness] is a value between 0x00
and 0x03 (between 0 and 3) according to the table below:
Value Brightness
0x01 25% <---= ?
0x01 50%
0x02 75%
0x03 100%
If the remember function is on, this command acts the same as

[Raquel]

Hello Kurt,

Please accept my apologoes for the mistake in the manual, we are getting it rectified as we speak. Here are the brightness levels on the VFD's:

0x00 - 100 %
0x01 - 75%
0x02 - 50%
0x03 - 25%

The factory default of 255 puts the display at 0x00 brightness value (100%)

Regarding auto scroll off, please have a look at PCN 2006-08-24-08 under Firmware Changes #2
http://www.matrixorbital.ca/PCNs/VK%20S ... 204-25.pdf

I hope that these answer your questions. Very glad to hear that you are happy with our displays.

Best Regards,