MX5 can't control fans
MX5 can't control fans
I have 2 120mm fans plugged into gpo 1 via a 3 pin splitter. It controls those perfectly, however when i plug another 2, via another 3 pin splitter, into gpo 3 it freaks out. The fans on gpo 3 pulse from high to low rpm rapidly and the display goes crazy displaying all kinds of wierd icons and letters. Each fan only draws .30A at full speed, but i only run them 50% max due to noise.
Its not plugged in right now as it was pissing me off so bad i had to take it out. Im goin to put it back in for further testing saturday and sunday.
All i know is it worked fine, controled rpm's fine with 2 120mm fans goin into one header. Then as soon as i put another 2 fans goin into another header the display freaked out displaying wierd symbols then the fans pulsed rapidly and i couldnt control them even when i adjusted the rpms.
All i know is it worked fine, controled rpm's fine with 2 120mm fans goin into one header. Then as soon as i put another 2 fans goin into another header the display freaked out displaying wierd symbols then the fans pulsed rapidly and i couldnt control them even when i adjusted the rpms.