You have mail

Yes, this is definitely the case.
How could this have happened? I'm in the Netherlands here.

(sigh)
Is it possible to reprogram it?

I'm trying to display the chars that match the push buttons
hex: C4 entersymbol and C5-C8 up dn rt lt arrows.
The characters that show up look like Chinese to me :o
So are the other chars between hex A0 and EF.
What could be wrong?
Or better how to restore the original font from the manual ...

Thanks Raquel, all clear now.

Does your "most likely" mean that it is safe to give it a try @ 24V?

Still don't know then what would distinghuish a 15V max from a 35V max model.

Somehow a wrong sticker was applied over the VCC connector of the BLK202-25 BG WB here. Warning 5V only. But below 7V it did not do anything. :-?

24V and 5V are standard available. Other voltages have to be made.
I am wondering if this display will take 24V as VCC.

IOW how to determine this.

It ...

Jon wrote:Hi Femme,

It is true the the older version does not support key reassignment (it is a nice feature isn't it!)

Where did you purchase the units from?

It is not normal for one unit to be sent out as one revision and the other a different revision.

Antratek in the Netherlands

I did send it back to the distributor and asked for a new version. Unfortunately they are out of stock. But if necessary I'll refer to this discussion.

Raquel and Jon, thanks for the help. It is working now. Also saved the string for future use.

About my other question
The BLK202 (green display) had a different print and was probably a Rev 2.1
Is it correct that it does not support the key reassignment?
Was I just unlucky in receiving an older ...

I already said

Femme wrote: Uproject does not seem to have an arrangement for changing keypad codes.
Typing it in the send string field won't accept the #254 either.
Is there a manual available or a help function for this program? Lots of it is unclear what it is meant to do or how to be used.

Or is there?

I am using a BLK202A WB BG display.
The controller it will be connected to accepts input only if the string is followed by either a #13 or a ";".
The idea is to change the keypad codes #254 #213, press down for a number and up for a ";"

I seem to have difficulties sending any char outside the ...