Matrix Orbital Corp

Hello....

There may be an error in the manual:
VK204-25_rev_20.pdf
Unless I'm totally reading it wrong....
As it is the weakend, I do not have a unit in front of me to verify it.
Just looking over the code / manual and found a couple of anomalies.
Will triple check on Monday.

.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.:~^~:.

10.4 Set VFD Brightness
Decimal 254 89 [brightness]
where [brightness] is a value between 0x00
and 0x03 (between 0 and 3) according to the table below:
Value Brightness
0x01 25% <---= ?
0x01 50%
0x02 75%
0x03 100%
If the remember function is on, this command acts the same as

Hello Kurt,

Please accept my apologoes for the mistake in the manual, we are getting it rectified as we speak. Here are the brightness levels on the VFD's:

0x00 - 100 %
0x01 - 75%
0x02 - 50%
0x03 - 25%

The factory default of 255 puts the display at 0x00 brightness value (100%)

Regarding auto scroll off, please have a look at PCN 2006-08-24-08 under Firmware Changes #2
http://www.matrixorbital.ca/PCNs/VK%20S ... 204-25.pdf

I hope that these answer your questions. Very glad to hear that you are happy with our displays.

Best Regards,