Page 1 of 1
GPO Default values...
Posted: Mon Mar 31, 2003 8:39 pm
by thedogcow
I was wondering, im looking at buying the usb lcd that u sell but am wondering about the gpo's... do they default to on when the lcd powers up, and if not is there a way to change it so they dO? Thanx
Posted: Mon Mar 31, 2003 11:13 pm
by Henry
They should be all off. Some of the new units (LK/VK202-24-USB, LK/VK202-25, LK/VK204-25) will get this option over time, but no unit can do this at the moment and no ETA can be given either.
Posted: Wed Apr 02, 2003 3:39 am
by Cheese
You can of course use a little bit of electronics to invert the default GPO state, but with high power GPO's it's a little bit of a pain (using solid state at least, clearly you could use relays too).
Rob.
Posted: Wed Apr 02, 2003 9:03 am
by JeffPh
i think u can set it to on using lcdc. in the configuration of GPO there is a on option at start and on at exit all 6 gpo's. Am using a 202 usb MX 222.
Posted: Wed Apr 02, 2003 9:07 am
by Cheese
JeffPh wrote:i think u can set it to on using lcdc. in the configuration of GPO there is a on option at start and on at exit all 6 gpo's. Am using a 202 usb MX 222.
Yes of course you can, but that won't turn them on when you switch your computer on. THe issue is if you are using the GPO's to control system vital fans, you don't want them to be all off when you start your computer
Rob.
Posted: Wed Apr 02, 2003 9:10 am
by JeffPh
hehe ur right
but it will just take about 10 secs at most upon boot up when u load lcdc to start with windows
just a thot not the cpu fan tho....