Page 1 of 1
wierd characters
Posted: Thu Mar 20, 2003 5:51 am
by bbcac
I just got my screen back from Matrix Orbital. When it powers up the firts pic comes on no prob. As soon as I start MODG the screen writes a small wierd characters over the pic in the top left corner. No mater what I do after that, weather it be clear the screen, turn off the backlight, or write a word to the screen, the screen just puts another wierd character in the upper left corner next to the last one.
Posted: Thu Mar 20, 2003 10:20 am
by Miles
Hello...
What unit do you have? What software program are you using to communicate with? Make sure you are communicating at the correct baud rate.
wierd characters
Posted: Thu Mar 20, 2003 11:07 am
by bbcac
i run a GLK12322. I've tried running modg and lcdc. Niether of the programs is able to communicate.
Posted: Thu Mar 20, 2003 3:43 pm
by Miles
Can you try these steps below and let me know how you make out:
1) Power off the unit.
2) Put a jumper on pins 6 & 7 of the keypad connector.
3) Power the display back on.
4) Make sure Mogd is set to 19200 and try turning the backlight off/on, contrast up/down, send text.