Fan connection on a LK202-24-USB rev1.4

Jester · Post by **Jester** » Wed Dec 17, 2003 10:43 am

Is it possible to connect two fans like paspt fans or s2 noiseblocker fans with an Y onto one fan advanced gpo without any risk ?

Thx

Miles · Post by **Miles** » Wed Dec 17, 2003 12:40 pm

The current rating per high powered GPO is 1 Amp. If the two fans combined power consumption does not exceed this limit. you should have no problem!! Be advised is you have more than 1 fan per GPO than you will not be able to read RPM...

Jester · Post by **Jester** » Wed Dec 17, 2003 4:52 pm

and if the two fans consumption exceed this limit what can be the consequences ?
why I will not be able to read RPM ?

thx

FrankFuss · Post by **FrankFuss** » Wed Dec 17, 2003 8:24 pm

You should not have any problem with more than one case fan on a GPO. Just add up the current for each fan and check that you are below 1.0A. I am running three 80mm case fans rated at 0.15A on one GPO. You also can read the RPM of one fan as long as you run the RPM signal from only that one fan back to the GPO.

Post by **Henry** » Wed Dec 17, 2003 8:34 pm

I run 2 80mm fans off one GPO, the LED fans we sell... heck you could do like 7 of them on one GPO.. LOL

Jester · Post by **Jester** » Thu Dec 18, 2003 12:34 am

ok I think it's will be ok so !

Thank You

Miles · Post by **Miles** » Fri Dec 19, 2003 3:19 pm

Good to GO!!!