MX2 Advance Gpo Fan Startup

dipan · Post by **dipan** » Thu Oct 02, 2003 9:34 pm

Hi Henry ...

I posted here after checking the manual on the MO main site. The instructions there, if I'm reading them correctly, say to "solder jumper 1" and "remove jumper 2" to power with external power. At least gathering from this forum, the manual is incorrect. Jumper 2 needs to be soldered according to concensus here on the forums. Am I reading this wrong? I have soldered that pad that was discussed in this forum and entered the appropriate commands into LCDC and I now have the unit powering up at startup running off of external power, not USB power.

Miles · Post by **Miles** » Mon Oct 06, 2003 9:00 am

Yes, you are correct, the manual is currently being updated and Jumper 2 needs to be soldered. Sorry for any inconvenience.

FrankFuss · Post by **FrankFuss** » Tue Oct 14, 2003 2:25 pm

I am ready to enable the High Power GPO power from the 3.5" floppy connector. I know I need to solder Jumper 2, but do I leave Jumper 1 in place or remove it?

Miles · Post by **Miles** » Tue Oct 14, 2003 2:31 pm

What part number do you have...?

FrankFuss · Post by **FrankFuss** » Tue Oct 14, 2003 2:45 pm

I have a new MX212 rev 1.4.

Miles · Post by **Miles** » Tue Oct 14, 2003 2:51 pm

Solder jump must be on for jumper 1 and jumper 2 to have fan control at power input!!

andrew72 · Post by **andrew72** » Wed Jan 14, 2004 2:20 pm

not sure where to put info in screen builder to get fans to boot and what to put in