GLK12232-25-SM : Keypad Setup

MattH · Post by **MattH** » Fri Aug 01, 2003 8:51 am

I have the GLK12232-25-SM and would like to set it up with a couple of LEDs (via the GPOs) and two buttons (to go forward and backwards through the screens in LCDC). Could someone talk me through what i basically need to do for this?

Thank-you

Post by **Henry** » Sun Aug 03, 2003 5:49 pm

Go though the getting started guide and manual on the lcdc website

www.lcdc.cc

as well, in our guides section under LCDC there is some information as well.

MattH · Post by **MattH** » Mon Aug 04, 2003 9:24 am

It's ok i've worked it out

The manual gave a different value than LCDC for when you press a key

Just need to make it's case now, i've only had it since September last year so i don't think i'm doing to badly

Miles · Post by **Miles** » Tue Aug 05, 2003 12:08 pm

The manual is currently being worked on and will be updated shortly...