Com port 2 problem

docaps · Post by **docaps** » Tue Apr 15, 2003 10:08 pm

I have a USB MX2 LCD screen and dispite configuring it to com port 15 and it working fine, if I restart LCDC it continues to try to find it on com port 2.

This produces an error and I need to go back to configure screen and re test the screen on com port 15

How can I may it stay on 15?

Post by **Henry** » Tue Apr 15, 2003 10:20 pm

it doesn't, in your control panel move the COM Port setting from 15 down to 4 or 5 as LCDC only supports upto 9 COM Ports currently.

docaps · Post by **docaps** » Fri Apr 18, 2003 6:03 am

Henry wrote:it doesn't, in your control panel move the COM Port setting from 15 down to 4 or 5 as LCDC only supports upto 9 COM Ports currently.

I can set the screen to almost all of the comports but it only works when you send something to the screen when I set it to 15.

Post by **Henry** » Mon Apr 28, 2003 1:17 pm

In the CONTROL panel you can change the port setting for any COM Port, change it from what ever you have down to 6 or something and then set LCDC to that COM port.

Miles · Post by **Miles** » Mon Apr 28, 2003 3:26 pm

Hello...

Check out this link as see if the problem is comparable

http://forums.planetdps.com/index.php?a ... 8d44905da1