VK204-25 TTL Mod

gapdev · Post by **gapdev** » Mon Apr 14, 2003 5:47 pm

How do you modify the VK204-25 for TTL Levels?

Which solder pads need to be jumpered, if any?

Thank you for any info,

Kenny

Post by **Henry** » Mon Apr 14, 2003 6:21 pm

1. Cut the pins where #1 is pointing at
2. Solder the two pads at #2

Miles · Post by **Miles** » Tue Apr 15, 2003 7:50 am

Once our new PCB revision is released, there will be no cutting involved!!!

gapdev · Post by **gapdev** » Tue Apr 15, 2003 3:04 pm

Thanks Henry, will give it a try.

Once our new PCB revision is released, there will be no cutting involved!!!

It makes sense to provide a jumper since not all of us use these things with computers

Kenny

Post by **Henry** » Tue Apr 15, 2003 3:23 pm

gapdev wrote:Thanks Henry, will give it a try.

Once our new PCB revision is released, there will be no cutting involved!!!
It makes sense to provide a jumper since not all of us use these things with computers

Kenny

This unit LK/VK204-25 is one of the older units. They have been last on the upgrade path because they just worked so well

All the new units have a nice option for TTL now. It still may involve soldering but there will be nice little pads to do so.