LK204-25PC ???

fredegar · Post by **fredegar** » Sat Jun 01, 2002 8:15 pm

i plan to buy one LK204-25PC
and i have 4 120mm each have 0.29a
and my cpu fan 80mm with 0.56a

is this unit can take all these fans

Post by **Henry** » Sat Jun 01, 2002 9:30 pm

Find out the power rating on the fans and then we will be able to tell you...

fredegar · Post by **fredegar** » Sun Jun 02, 2002 1:18 am

hello! thank you for answer me...

i have 4 X 120mm
1 delta 0.20 amp @ 12 volt or 2.4 watt
3 panaflo 0.18 amp @ 12 volt or 2.16 watt

i think i prefer to put the cpu fan on a rheostat because it is to loud

fredegar · Post by **fredegar** » Sun Jun 02, 2002 11:03 am

hello again !
can i tell the module to start the fan automatically when it over (?? celcius) i chose and start off the fans when this temp is reach?

i have another question.

i understand you are in canada,
so if i want to buy from your site and
i came from quebec , am i gone a save the brookerage?

fredegar · Post by **fredegar** » Sun Jun 02, 2002 8:45 pm

i count on an answer , to make my decision..
so i hope somebody can help me

fredegar · Post by **fredegar** » Sun Jun 02, 2002 9:47 pm

Post by **Cheese** » Mon Jun 03, 2002 1:28 am

Yeah your fans will be fine on the -pc, yes you can switch them on temperature provided your computer has some method of mesuring the temperature (mobo temperature probes etc.) and... local canadian sales? Give them a ring and talk to Adam

r.

<font size=-1>[ This Message was edited by: Cheese on 2002-06-03 01:29 ]</font>

jleach · Post by **jleach** » Mon Jun 03, 2002 9:07 am

Just to clarify a little on the software control of the fans. There is no software built in to the display that lets you do that. You'll need to use MBM and LCDC for example.

Post by **Henry** » Mon Jun 03, 2002 2:37 pm

that's right.

tarzan · Post by **tarzan** » Wed Jun 12, 2002 7:29 am

Will this mean that i can buy a unit, and connect my case fans to the general purpose pins ? So that i can tell lcdc to keep my temp. at a specified value ?

Post by **Henry** » Wed Jun 12, 2002 9:46 am

Post by **Mat-Moo** » Wed Jun 12, 2002 11:05 am

On 2002-06-12 07:29, tarzan wrote:
Will this mean that i can buy a unit, and connect my case fans to the general purpose pins ? So that i can tell lcdc to keep my temp. at a specified value ?

Actually LCDC can't automatically keep the temperature the same (yet) but it is possible based on the current temps to set the state of a GPO to either Off/Flash/On (Flash will pulse it at a constant rate). FOr more details see
http://lcdc.planetdps.com/help/plugin_MM5.htm