I just purchased a LK204-25-WB and can not get the vertical bars to display in the narrow format. I send the [254] [115] codes but they show as wide bars.
Any help would be appreciated!
--------------------------------------------
Found the answer myself. A product change notification explains that Custom Characters must be created.
http://www.matrixorbital.ca/PCNs/LK%20S ... 204-25.pdf
LK204-25 Vertical narrow bars same size as wide bars
Hello,
Thank you for posting on the forum.
Sorry for not getting back to you soon enough, but hey, you found what you needed. I am attaching here though the custom char definition for skinny / narrow vertical bars to make your job easier:
/254//193//2//0//14//14//14//14//14//14//14//14/
/254//193//2//1//0//0//0//0//0//0//0//14/
/254//193//2//2//0//0//0//0//0//0//14//14/
/254//193//2//3//0//0//0//0//0//14//14//14/
/254//193//2//4//0//0//0//0//14//14//14//14/
/254//193//2//5//0//0//0//14//14//14//14//14/
/254//193//2//6//0//0//14//14//14//14//14//14/
/254//193//2//7//0//14//14//14//14//14//14//14/
/254//192//2/
Try clicking the 'Demo Thin Bar' button in uProject after sending the commands above. You should have your narrow vertical lines.
Thanks,
Thank you for posting on the forum.
Sorry for not getting back to you soon enough, but hey, you found what you needed. I am attaching here though the custom char definition for skinny / narrow vertical bars to make your job easier:
/254//193//2//0//14//14//14//14//14//14//14//14/
/254//193//2//1//0//0//0//0//0//0//0//14/
/254//193//2//2//0//0//0//0//0//0//14//14/
/254//193//2//3//0//0//0//0//0//14//14//14/
/254//193//2//4//0//0//0//0//14//14//14//14/
/254//193//2//5//0//0//0//14//14//14//14//14/
/254//193//2//6//0//0//14//14//14//14//14//14/
/254//193//2//7//0//14//14//14//14//14//14//14/
/254//192//2/
Try clicking the 'Demo Thin Bar' button in uProject after sending the commands above. You should have your narrow vertical lines.
Thanks,
Raquel Malinis
Design and Development
Matrix Orbital
Design and Development
Matrix Orbital