Hi!
It looks like the MX2 LCD is not using a standard USB protocol that will work under QNX 6.3. Has anyone written a USB driver for QNX? Any tips on writing my own? Thanks.
QNX drivers for MX2
-
Ray
- Matrix Orbital
- Posts: 745
- Joined: Thu Dec 13, 2001 4:00 pm
- Location: Earth.... I think..
- Contact:
The MX2 uses a FTDI chip (FT232) for usb comminication, FTDI lists someone that made some drivers QNX drivers for the FT245 series in its 3rd party section over here.
You might be able to use that as a starting point or perhaps using a regular serial display would be easier to work with in QNX.
You might be able to use that as a starting point or perhaps using a regular serial display would be easier to work with in QNX.