LK202-205 rev 1.12

seeksincerity · Post by **seeksincerity** » Tue Jul 19, 2005 4:38 pm

I would like to know if this is 5 or 12 v ? Also, can I use a modified floppy cable if it is 5v or a unmodified floppy cable if it is 12v ?

Thank you.
Anthony

Tom · Post by **Tom** » Tue Jul 19, 2005 5:05 pm

Hi seeksincerity,

If you have a 7805 linear regular above the power connector, then it is a 12V module. If not, then you have a 5V module. All our units come default as a 5V module. Either way, you must use a modified floppy power cable. For more details on the unit, you can refer to the manual at http://www.matrixorbital.ca/manuals/LK_series/LK202-25/

If you have anymore questions or concerns, please feel free to post.

Best Regards,

seeksincerity · Post by **seeksincerity** » Tue Jul 19, 2005 5:50 pm

Hi Tom,

Thanks for the fast reply. Above the power connector there are 3 cute looking things

The first one is cyndrical and is black and silver, the next is a yellow rectangle and the top one is a black square. Unfortunately, the manual didn't mention which one they were showing.

If it does turn out to be 12v which pin gets the yellow and which the black, as they are not numbered ?

Thank you.
seeksincerity

Miles · Post by **Miles** » Wed Jul 20, 2005 7:42 am

Can you verify that it is a 12V module? If not, can you please take a pic of the PCB and we will let you know. Please, do not attempt to apply power if unsure of the voltage requirements.

seeksincerity · Post by **seeksincerity** » Wed Jul 20, 2005 11:31 am

Hello Miles,

I have taken 2 very good pictures, but, can't figure out how to send them.

Thank you.
seeksincerity

Miles · Post by **Miles** » Wed Jul 20, 2005 11:35 am

You can send them to my email account: myero@matrixorbital.ca

seeksincerity · Post by **seeksincerity** » Wed Jul 20, 2005 12:14 pm

The picture are on their way.

Thank you.

Miles · Post by **Miles** » Wed Jul 20, 2005 12:21 pm

Thanks!