GLK12232-25-SM installation help

pm1225 · Post by **pm1225** » Thu Feb 03, 2005 11:37 am

The device is connected to the serial port and it is getting the power from the PC via the floppy cable connector. The device powers up and the backlight stays on but I don't see anything else. I am unable to get anything displayed on it with the MOGD program.

Miles · Post by **Miles** » Thu Feb 03, 2005 11:55 am

Hello...

What type of cable are you using to connect to the com port from the module??

pm1225 · Post by **pm1225** » Thu Feb 03, 2005 11:56 am

Miles wrote:Hello...

What type of cable are you using to connect to the com port from the module??

The 4BR cable from Matrix Orbital.

Miles · Post by **Miles** » Thu Feb 03, 2005 11:58 am

Can you tell me what the orientation of the pins are according to color??

pm1225 · Post by **pm1225** » Thu Feb 03, 2005 12:05 pm

Miles wrote:Can you tell me what the orientation of the pins are according to color??

Actually its not the 4BR cable. Someone made the cable.

DISPLAY Computer
1 ---- +5VDC
2 ---- RX Display ---------------- 3 TX Comp
3 ---- TX Display ---------------- 2 RX Comp
4 ---- GND ----------------------- 5 GND

Tom · Post by **Tom** » Thu Feb 03, 2005 2:19 pm

When you power up the display, do you see a startup screen?