Internal USB connections to header? What goes where?

NeilFawcett · Post by **NeilFawcett** » Fri Apr 09, 2004 4:32 am

I have an internal header cable to go from my MX4 to my USB2 header on my motherboard.

The motherboard has the following connections shown:-
USB+5v
USB-5v
LP5+
LP5-
LP4+
LP4-
GND
NC

The cable has:-
Ground
+5v
+D
-D

What goes to where?

Thanks...

Miles · Post by **Miles** » Mon Apr 12, 2004 11:20 am

What type of motherboard do you have? Can you give me the link for the datasheet?

NeilFawcett · Post by **NeilFawcett** » Mon Apr 12, 2004 3:21 pm

Miles wrote:What type of motherboard do you have? Can you give me the link for the datasheet?

It's an Asus P4PE

http://www.asus.com/support/download/it ... lName=P4PE

Post by **Henry** » Mon Apr 12, 2004 3:59 pm

NeilFawcett wrote:
Miles wrote:What type of motherboard do you have? Can you give me the link for the datasheet?
It's an Asus P4PE

http://www.asus.com/support/download/it ... lName=P4PE

soooo sloooooooow to download........

hum hum hum...

solves a Rubik's Cube...

beats HAL-9000 at a game of chess...

figures out how to divide by 0...

discovers the location of Atlantis...

builds a flux capacitor...

Post by **Henry** » Mon Apr 12, 2004 4:07 pm

ok, the header is

(+5)(LP5-)(LP5+)(GND)(NC)
(+5)(LP4-)(LP4+)(GND)

Connect to one row, top or bottom...

+5v => +5
+D => LP4+
-D => LP4-
Ground => GND

NeilFawcett · Post by **NeilFawcett** » Tue Apr 13, 2004 1:08 am

Henry wrote:ok, the header is

(+5)(LP5-)(LP5+)(GND)(NC)
(+5)(LP4-)(LP4+)(GND)

Connect to one row, top or bottom...

+5v => +5
+D => LP4+
-D => LP4-
Ground => GND

Thanks... So I'll just connect to the pins along the bottom then...

Miles · Post by **Miles** » Tue Apr 13, 2004 10:29 am

That'll be perfect, just make sure you connect each pin as Henry outlined!!