The cable I currently have is a Belkin DB9. Is this the same as what you suggested??

STIG.....

I think you're right.... I used an old DB9 cable I found layin' around. Can I get this serial cable from the local PC shop? What spec. should I be lookin' for??

Thanks

BTW....The settings on the software matched the physical connections.

Thanks for the reply.....

Yes I did try COM2. I made sure all the connections [power and data] were correct. My NK204 has the wide volt. option and I thought I may have incorrectly switched the cables, but the blinking cursor is a good indication that I did it right. As far as the device is ...

I need some help...

I just recv'd my NK204 [w/ wide voltage option] from MO. After reading and following the instructions for installation [and I went over several times] The only thing I get on the panel is a blinking cursor and nothing else. The unit is on COM1, 19200 baud, 12v plug. I just want ...

ok.

my goal is to have a decent LCD panel on my modestly modded sx1040 that would display temp, Mhz, clock cycles, CPU type, graphics etc....IN BLUE!!!!!. i know the software drives these diff. features so it matters what hardware i get.

the lk204-25 looks decent....i need input on other models as ...