|
It is currently Wed May 22, 2013 8:25 pm
|
View unanswered posts | View active topics
 |
|
 |
|
| Author |
Message |
|
phildogginit
|
Post subject: LVK204-25 PCB V.3.0 -- messed up jumper move, any hope?  Posted: Fri Jan 20, 2012 6:59 pm |
Joined: Fri Jan 20, 2012 6:52 pm
Posts: 1
|
|
I attempted to move the jumpers from the rs232 square to the I2C square but made a mess of it, being inexperienced and having shaky hands.
There currently are no jumpers in any of the 5 squares.
What can I do to fix it? I want to run in I2C mode.
thanks
Phil M
|
|
|
|
 |
|
Clark
|
Post subject: Posted: Mon Jan 23, 2012 11:00 am |
| Matrix Orbital |
 |
Joined: Fri Aug 17, 2007 10:58 am
Posts: 755
Location: Matrix Orbital
|
|
Hi Phil,
The protocol resistors have a value of 0ohms; if you have removed them and all pads are intact you are in good shape. To bridge the connections for I2C, you can use a blob of solder on each of the two connections required, which should be easier than playing with those resistors.
Thanks,
Troy
_________________
Troy Clark
Technical Support
Matrix Orbital
|
|
|
|
|
|
|
|
 |
|
 |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
{ SMARTFEED }
