Matrix Orbital Corp

has anyone had any success with mounting a pcbay ready matrix orbital (like this):


into a chenming case which is made for use with drive rails and really wants to have nothing do with the MO's screws (like this):


tnx for any help!

if all else fails could you remove the drive rails and drill your own holes?

yea its possible but i was hoping to find alternatives before raising a dremel to my drivecage

Yes... I just got my Matrix Orbital (Same model pictured above, I am too lazy to type out the model numbers) and I have a chenming case and it works well... It is not a perfect fit, but it works... Just screw on the clips to either side and it slides right in with too much problems.