Page 1 of 1
Posted: Fri Sep 06, 2002 8:07 am
by steve
I have drawing for a facia to put a 204-25 in to two 3.5 bays you need 7.5mm above the bays or move the 17.4 dim down 7.5mm and then you will need 7.5 below. my case is a little large across the 3.5 bays so reduce the 104mm down accordingly I just had enough room to get a HDD in the bracket and get the screws in. sorry its in metric but that
Posted: Fri Sep 06, 2002 3:21 pm
by Henry
if you have room bellow or above you shouldbe able to, there is a few picture in the gallery of this being done.
Posted: Sat Sep 07, 2002 9:46 am
by steve
No Henry you misunderstod I have a CAD drawing of a bay front I have made simalar to your double 5.25 bay but for 3.5 bay that if any one wants its there for them. I made mine in 1mm alli in about 30 min my case is also hand crafted that took me about a fortnite including ACAD drawing, 3d modeling then renderding its ok but not perfect but it is unique. steve
Posted: Wed Sep 18, 2002 10:20 am
by steve
