program errors GTT70
Posted: Sun Feb 03, 2019 1:51 pm
Hi Clark, in March last year we were chatting...
I have another mistake.
I use GTT70A with RS232 interface.
"Enter Mass Storage Mode"command is not executed.
On the monitor it is visible that the command was executed (the logo of USB of the connector), but in Windows 7 is not defined.
The same tried GTT70A USB --> USB connector logo + Windows 7 identifies it as a flash card.
Tried to check in tester mode diode test to determine the integrity of chain and cable. Electrical signals are coming
correctly. So it's all about the software.
Please help to understand.
PS: Firmware_R2.13.0.10563, Bootloader_R1.8.0.10540.
I have another mistake.
I use GTT70A with RS232 interface.
"Enter Mass Storage Mode"command is not executed.
On the monitor it is visible that the command was executed (the logo of USB of the connector), but in Windows 7 is not defined.
The same tried GTT70A USB --> USB connector logo + Windows 7 identifies it as a flash card.
Tried to check in tester mode diode test to determine the integrity of chain and cable. Electrical signals are coming
correctly. So it's all about the software.
Please help to understand.
PS: Firmware_R2.13.0.10563, Bootloader_R1.8.0.10540.