Page 1 of 1
Posted: Mon Jul 15, 2002 8:21 am
by americanfreak
Ok,
1)Do I have to have the 25 keypad to make the LCD's work or is all the functions controled from the software?
2)Can I assign keyboard combo's to make it do the different functions or is it done automaticlly after you setup the software.
3) Do I have to setup the LCD everytime I reboot? I heard, about a year ago, that you had to do this.
Posted: Mon Jul 15, 2002 11:57 am
by Henry
1. You configure the software to react to the keypresses.
2. Depends on the software you use.
3. Most LCD software will save your settings.
Software has come a long way since last year!
_________________
Henry J.
Technical Support
Matrix Orbital
<font size=-1>[ This Message was edited by: Henry on 2002-07-15 11:58 ]</font>
Posted: Mon Jul 15, 2002 2:24 pm
by americanfreak
I'm still alittle confused about question 1,Monday morning ya know :-)
Do I have to buy the optional keypad to make it work?
thanks
Posted: Mon Jul 15, 2002 3:00 pm
by Henry
On 2002-07-15 14:24, americanfreak wrote:
I'm still alittle confused about question 1,Monday morning ya know :-)
Do I have to buy the optional keypad to make it work?
thanks
Depends on what you buy... if you buy the BLK202A(or BVK202A) units, there is a keypad on the fron of the insert.
Posted: Mon Jul 15, 2002 3:04 pm
by jacklord
You do not NEED a keypad, but they are helpful.
Posted: Mon Jul 15, 2002 3:57 pm
by americanfreak
Thanks jacklord. That's all I needed to know.