Page 1 of 1
Posted: Thu Jun 27, 2002 4:01 pm
by Butch
I need to take the above unit on a double bay insert apart to stealth the black insert to match a Lian LI case and am wondering just take the 4 screws out and its done? Any tip I need so I don't ruin a great VFD. Butch
Posted: Fri Jun 28, 2002 10:46 am
by Henry
when you take the screws out you do have to replace them so that you do not risk letting the PCB short out together.... I'm not totaly shure what you are planning...
Look here for ideas...
http://www.lcdforums.com/forums/viewtop ... &forum=9&6
Posted: Fri Jun 28, 2002 12:07 pm
by Butch
Sorry Henry!! I just need to take it apart so I can use your double bay insert for a template so I can make a stick on over top of yours so it matches the mod I am working on for front bezel. So if I just take out screws to get bare bay insert I will just put them back after I make stealth stick on for double. I know I drink to much beer but it looks like I just remove screws and put them back.
??
<font size=-1>[ This Message was edited by: Butch on 2002-06-28 12:11 ]</font>
<font size=-1>[ This Message was edited by: Butch on 2002-06-28 12:12 ]</font>