Matrix Orbital Corp

Hi,

First off let me say I am new to the modding community (extremly new). I already have read a lot of information to the subject. I saw the idea of the LCD and now want to add one of them to one 5.25 bay.

I was just reading a review and they said http://www.matrixorbital.com/products/g ... -25-sm.htm would fit into a 5.25 bay. Is this true?

I am also looking at http://www.matrixorbital.com/products/blc2021.htm this I bilive already comes with everythign I need to put into a 5.25 bay.

In your guys opion which would be better? Do you have any other you would reccomend? Also I would like the bezzle to match the lian case (pc-65 aluninum). Do I have to take one of the empty 5.25 face plates already on there and do all the cutting myself? Or is there anywhere I can buy one for LCD's?

As I told you I am new to the modding community, so if I have to do the cutting myself, can someone point me to some guides on how to perform this task.

Also Thank you for any information you make give.

modding the faceplate is easy. I bought a lk202-25 in a pc bay insert. Then I cut off about 1/8 inch around the sides. traced the screen outline, and then cut out the center part. I believe that only a 2x20 display will fit in a single bay. see here:
http://www.lcdforums.com/forums/viewtop ... &forum=1&5
And here:
http://forums.bit-tech.net/showthread.p ... eadid=8060

On 2002-04-28 06:07, gb57666 wrote:
modding the faceplate is easy. I bought a lk202-25 in a pc bay insert. Then I cut off about 1/8 inch around the sides. traced the screen outline, and then cut out the center part. I believe that only a 2x20 display will fit in a single bay. see here:
http://www.lcdforums.com/forums/viewtop ... &forum=1&5
And here:
http://forums.bit-tech.net/showthread.p ... eadid=8060

Thanks for posting a link my method of mounting in my lian-li. you saved me a job lol

Later

Happy Modding

AW3K