LK204-25 - move jumpers from RS232 to I2C, is that possible?
Posted: Mon Dec 19, 2011 5:01 pm
Hi Guys,
I'm forced to move a project of mine from RS232 to IC2, and when looking at the back of my two LK204-25's i see jumpers for IC2.
The revision number on the back of the board is 2.0 and a small sticker with 10M05-1259.
Can i desolder the RS232 jumpers (i hope 0 ohm), and solder the IC2 jumpers shut and hook the IC2 interface to the 4 pin (power) connector ?
Theo Ekelmans (hobby builder)
The Netherlands
I'm forced to move a project of mine from RS232 to IC2, and when looking at the back of my two LK204-25's i see jumpers for IC2.
The revision number on the back of the board is 2.0 and a small sticker with 10M05-1259.
Can i desolder the RS232 jumpers (i hope 0 ohm), and solder the IC2 jumpers shut and hook the IC2 interface to the 4 pin (power) connector ?
Theo Ekelmans (hobby builder)
The Netherlands