Matrix Orbital Corp

I seem to be powering the device OK, but I'm completely unable to drive it from mogd.

It cannot automatically detect the device (unless I press a button, then it suggests rubbish).

I've set COM5 (my "prolific" USB serial adapter).

baud rate at 192000

selected the correct screen and only PCB rev.

I can't seem to make it do anything other than show the splash screen. I've tried reading some bits of data too, but it just times out, unless I press buttons, then I get more gibberish.

Anyone suggest anything, I've already tried all standard baud rates and resetting the screen.

Thanks for posting on the forum.

Have you by any chance tried the display out on a different computer with a real serial comport?

Also, you might want to press on the bottom left corner key as you power the display up (manual override); this will make sure that the display will be at 19,200 baud (in case it has been changed).

Got it working now, I think my USB Serial adapter may have a null modem built in.