Matrix Orbital Corp

Hi ive just got the nk204 throught the bit-tech deal . Ive wired it up and check everything twice (even 3 times) . Iam get power to the unit as i have the backlight on and there is a flashing square in the corner. But once i load up lcdcenter all that comes up is a load of stange symbols and squares . Any1 know what the prob is ???
I tryed changing com port and still the same .
[Edit] I got LCDC working , but not LCDceneter any1 know why ??

Thx for any help

<font size=-1>[ This Message was edited by: Tj on 2002-04-06 07:56 ]</font>

<font size=-1>[ This Message was edited by: Tj on 2002-04-06 08:15 ]</font>

Check what speed LCD Center 2.0 is set to. It sounds like its not 19.2K... I would stick with LCDC thoughs

ok i thoguht it would be some thing simple , so much to learn :E . Iam deff going to stick with LCDC its a good program (ive posted a few Qs in the LCDC topic)

Thx for help