I'm having problems getting my GX to work with DriveCore(GX_SptwarePack_AUG20_2008_rev1). When I load the drive core software my LCD shuts off. The device does not list/display in any of the utilities/setup software. If I uninstall DriveCore, uninstall the driver from Device Manager, restart and then reinstall the driver I get the blue GX logo. I can then see the device with the firmware utility the device listed is
"GX 240x64 FW:2.0 Rev:2235 Serial:G11A8D83636A50000002" .
Any assistance on this matter is greatly appreciated
Hardware
Vista 64bit
I7 920
12 GB DDR3
GTX 295
SuperMicro Mobile Cage M28E2 with 8 x SAS Seagate Savvios 146GB Raid 10
T-Balancer BigNG (Fan Controller) + Sensor Bus (Unplugged from usb connection for now)
Vista64 & Drivecore Problem
Moderator: Mods
The device stays in the device manager until usb unplugged.
When I unplug (USB) and reinsert the USB device I hear the device connection bell and can confirm the device in Device Manager
Matrix Orbital Displays --> Matrix Orbital GX Series rev 2 Display(XP Mode)
Sometime I can connect with the LCD defaults configuration utility(driveCore service not started). However I get mixed results from flashing screen to blank screen. A few times this utility locked up/crashed.
When I unplug (USB) and reinsert the USB device I hear the device connection bell and can confirm the device in Device Manager
Matrix Orbital Displays --> Matrix Orbital GX Series rev 2 Display(XP Mode)
Sometime I can connect with the LCD defaults configuration utility(driveCore service not started). However I get mixed results from flashing screen to blank screen. A few times this utility locked up/crashed.