Page 1 of 1
MX630 - Verticle line always on
Posted: Thu Jan 11, 2007 8:46 pm
by tuocekim
I just installed my MX630 and noticed that on both line 1 and 2 (on the same verticle line) a : and | are constantly displayed. Clearing the display does not clear these two characters. Any help would be appreciated.
-Mike
Posted: Fri Jan 19, 2007 3:14 pm
by Raquel
Hi Mike,
Thank you for your post.
Its unfortunate that your PLED display looks like it may be defective. How old is your module? If it is under a year old, it is covered under warranty.
Please email
support@matrixorbital.ca if you want to send the module back for repair.
Thanks,
Posted: Fri Jan 19, 2007 9:03 pm
by tuocekim
It's only about a month old, but later that night the two lines went away and haven't returned yet. I'll keep an eye on it, but it's been running great since.
-Mike