Matrix Orbital Corp

Hi,

I've just finished the circuit for connecting my quadrature encoder to the keypad input on the MO and it appears to work nicely. I do have one problem though. In order to get the input to work I have to set the debounce value to either 0 or 1. That's fine and works perfectly until the unit is power cycled when it stops working. When I reset the value to 0 or 1 it works correctly again so I assume it's forgetting the value for some reason. It says in the manual that it should remember this value, is this correct? If so what am I doing wrong? I'm using Display Tuner 0.7 to set the value.

Thanks, Tim

Crisis averted, I found the remember function in the setup utility!!

Hi Tim,

Glad you found something that will work for you. You can also set the remember command using the command 254 147 1 (1=On,0=Off). Thanks for the post.

--
Jon