Page 1 of 1
MX232 & Fans
Posted: Sun Jul 31, 2005 10:18 am
by uxbod
Hi,
could somebody please point me to a manual or posting that shows how to connect fans to the display ... i have three 120mm fans on a radiator in a watercool setup that I would like to monitor.
TIA
Posted: Tue Aug 02, 2005 2:09 pm
by Tom
Hi Tia,
The manual for the MX232 can be found at
http://www.matrixorbital.ca/manuals/LK_ ... SB_140.pdf
You will need to connect a floppy power cable highlighted as high power input shown on page 4 of the manual. There are 3 pin fan headers above the high power input.
If you have anymore questions, please feel free to post.
Best Regards,
Posted: Mon Aug 08, 2005 8:25 am
by uxbod
Thanks,
but how much ampage can each fan channel take?
TIA
Posted: Mon Aug 08, 2005 9:01 am
by Tom
uxbod,
Each fan header rated for safe operation is a maximum of 12V, 1000mA.
If you have anymore questions, please feel free to ask.
Best Regards,