Page 1 of 1
Temp probe
Posted: Tue Oct 26, 2004 3:39 pm
by jhego
I setup the Dallas One wire and the temp reading value is NYR. Anyway to fix this?
Posted: Tue Oct 26, 2004 3:58 pm
by Tom
You need to reprogram the line for displaying the probe's temperature in the screen builder again. The probe's ID could have changed, so it might not be matching with the one on the line.
Best Regards,
Posted: Wed Oct 27, 2004 5:19 am
by Mat-Moo
NYR is just Not Yet Read, give it a chance after you hit start.
Posted: Wed Oct 27, 2004 9:32 am
by jhego
oh i found the problem, the sensor type is on N.A. I set it up to the correct one and it works fine now.
Posted: Wed Oct 27, 2004 2:07 pm
by Tom
Glad you got it working!!!!
Best Regards,