Matrix Orbital Corp

I have just bought a Mx222 and was happy to get it all installed without any issues, im having some probs tho trying to sort out the software side, i cant figure how to get it to display my cpu temps (1 of the main reasons i got the mx222) also it says i have plug ins but there not active, how do i activate them ???

thanks in advance

Max

Do the following steps:

1) Plug in your temperature probe
2) Press the configuration soft key
3) Under "Connection and type" make sure you have LK202-24-USB or MXX rev 1-3 selected.
4) Test your display to see if you have a correct connection
5) Under the Advanced MXx features section, highlight Dallas one wire
6) Press the scan interface softkey and follow the instructions that pop up on the screen.
7) After following the instructions your temperature probe should be installed
8 ) Press the checkmark soft key to save the configuration.


Also in the configuration section highlight plugin selection. If you notice on the right side there are many plugins you can activate by checking the boxes. Some of the plugins won't be active until an application is executed like winamp 3 or mm5. You must press the checkmark soft key to save the configuration.

The link below can give you some information on how to configure your dallas one wire or plugins.

http://www.lcdc.cc/help/configuration.htm#amxxd1w

Thanks for the reply tom,

I have an ASUS p4c800e delux, will the display not work off the sencors that ar already on the board, there is softwware with the board that tells me CPU temp, i thought the display would work the same way as the asus software