Matrix Orbital Corp

i got the dallas temp probs, and i got them hooked up to the display..

Whats the Best way to attach to probs.. I have 3 Water Cooling Blocks on my PC. I tried Taping but it dont hold, whats the best way to make them stick or hold without messing up the tempautre reading...

Pawn

I use a tiny drop of super glue. You can easily remove the sensor with a small watch screwdriver without any damage, at a later date. You can also use heat prove tape which is quite strong, only thing i can't see anywhere you would be able to buy it.

should i take a tiny drop of super glue on the flat part of the sensor or, put the sensor flat on the water block then place super glue over the top?

A pin head on the flat surface, and press this to a flat surface on your waterblock.

thanks man