dallas sensor reading

morpheus-95 · Post by **morpheus-95** » Sat Jul 24, 2004 12:51 pm

hello

is there a way of changing the read out of this sensor as i only want to get the reading of say 35c not 35.56c.

i want to loss the last two numbers after the Decimal point.

Tom · Post by **Tom** » Mon Jul 26, 2004 12:27 pm

Unfortunately I haven't discovered how to do this, but if you go to the forum below you may be able to find an answer.

http://forums.lcdc.cc/

MD · Post by MD » Tue Aug 24, 2004 2:35 pm

[%rnd%[#$AdvDalVal009]%]

just change the 009 to the probe number you want