Matrix Orbital Corp

i just got a mx213 for another computer i'm building, when i connected the fans to the fan sensors on the mx, and boot the computer everything is fine until i run lcdc, right when the application loads, the fans that are connected turn off, the red LED's still illuminate on the fans, but the blades themself stop spinning. also, when i run MDM my processor shows on the LCD as a AMD XP running at 3.42 ghz... funny because i have a p4 extreme edition at 3.4 ghz... how can i rectify this?? thanks alot guys..

For the AMD bit, just edit the screen (FOr some reason Henry did that as a static screen), at a guess I would say you have not told LCDC what to do with those fans, you can eitehr put them into advanced mode http://www.lcdc.cc/help/configuration.htm#amxxgpo and set the start/stop values that you want for the gpo % wise.