Page 1 of 1
Internal USB connections to header? What goes where?
Posted: Fri Apr 09, 2004 4:32 am
by NeilFawcett
I have an internal header cable to go from my MX4 to my USB2 header on my motherboard.
The motherboard has the following connections shown:-
USB+5v
USB-5v
LP5+
LP5-
LP4+
LP4-
GND
NC
The cable has:-
Ground
+5v
+D
-D
What goes to where?
Thanks...
Posted: Mon Apr 12, 2004 11:20 am
by Miles
What type of motherboard do you have? Can you give me the link for the datasheet?
Posted: Mon Apr 12, 2004 3:21 pm
by NeilFawcett
Miles wrote:What type of motherboard do you have? Can you give me the link for the datasheet?
It's an Asus P4PE
http://www.asus.com/support/download/it ... lName=P4PE
Posted: Mon Apr 12, 2004 3:59 pm
by Henry
soooo sloooooooow to download........
hum hum hum...
solves a Rubik's Cube...
beats HAL-9000 at a game of chess...
figures out how to divide by 0...
discovers the location of Atlantis...
builds a flux capacitor...
Posted: Mon Apr 12, 2004 4:07 pm
by Henry
ok, the header is
(+5)(LP5-)(LP5+)(GND)(NC)
(+5)(LP4-)(LP4+)(GND)
Connect to one row, top or bottom...
+5v => +5
+D => LP4+
-D => LP4-
Ground => GND
Posted: Tue Apr 13, 2004 1:08 am
by NeilFawcett
Henry wrote:ok, the header is
(+5)(LP5-)(LP5+)(GND)(NC)
(+5)(LP4-)(LP4+)(GND)
Connect to one row, top or bottom...
+5v => +5
+D => LP4+
-D => LP4-
Ground => GND
Thanks... So I'll just connect to the pins along the bottom then...
Posted: Tue Apr 13, 2004 10:29 am
by Miles
That'll be perfect, just make sure you connect each pin as Henry outlined!!
