Matrix Orbital Corp

When I use the Screen Builder and then go into the events section. The three LEDs 1-3 are preconfigured to work with email, mm5 temp and fan speed. If I click on LED2 or LED3 the ones configured with MBM5 I receive and error and LCDC exits.

The error is:

The program raised on a non-continuable exception and will be closed.
-------------------
Exception was:
Access Violation at address 0054172E in module "LCDC.exe". Read adress FFFFFFFF
-------------------
Get Last Error:
The specified module could not be found.
-------------------

I'm using an MX4 on an ASUS p4t533, LCDC is latest version.
Any ideas? Thanks, Tre

US.Tresark wrote:When I use the Screen Builder and then go into the events section. The three LEDs 1-3 are preconfigured to work with email, mm5 temp and fan speed. If I click on LED2 or LED3 the ones configured with MBM5 I receive and error and LCDC exits.

The error is:

The program raised on a non-continuable exception and will be closed.
-------------------
Exception was:
Access Violation at address 0054172E in module "LCDC.exe". Read adress FFFFFFFF
-------------------
Get Last Error:
The specified module could not be found.
-------------------

I'm using an MX4 on an ASUS p4t533, LCDC is latest version.
Any ideas? Thanks, Tre

you should try this one over at lcdc forums www.lcdc.cc