Page 1 of 1
LK162-12 Jumper Settings, I2C
Posted: Mon Mar 08, 2004 6:09 am
by thelab
Can someone please tell me all the jumper settings for the LK162-12 when being powered by 5 volts and running in I2C mode? The manual says that this device comes set to I2C mode by default but my board does not have the same jumpers set as the pictures show.
Thanks for the help.....
Posted: Mon Mar 08, 2004 11:42 am
by Miles
Can you tell me what PCB revision you currently have??
Board Revision
Posted: Tue Mar 09, 2004 7:30 am
by thelab
The board revision is R.22....
Thanks
Posted: Fri Mar 12, 2004 9:38 am
by Miles
If your PCB revision is R.22, you should have the required jumps set for I2C at default. These jumps are located just to the right of the 4 pin power connector labelled "I". If you are referring to the picture in the manual under section 2.1.7, please be advised that this picture is incorrect and the solder jumps should be on the two pads labelled "I". Sorry for any confusion regarding this matter.