Problem with my fans connected to the GPO's

cadburys man · Post by **cadburys man** » Fri Mar 05, 2004 2:57 pm

When i connect my case fans to the gpo outputs they spin really slow. Can anyone help?
I have an MX212.

Thanks in Advance

Daz.

Miles · Post by **Miles** » Fri Mar 05, 2004 3:18 pm

On your MX212, what power cable do you have attached to the white 4 pin connector, and what is your jumper selection on, low powered GPO's or high powered GPO's...? Please see the manual for further reference regarding high powered GPO's vs LPO's selection...

cadburys man · Post by **cadburys man** » Fri Mar 05, 2004 3:36 pm

Hi,

I have made a cable from a molex connector to a floppy connector connected from the main power supply and the jumper is on the middle and far right connectors.
I am quite new to this so i don't fully understand all the technical jargon involved

Daz.