Matrix Orbital Corp

Ive purchased the mx222 rev 1.4, i wish to connect 3 case fans, three inverters for 6 CCFLs. is it possible with the current GPO setup or does it require modification??

Can the low power GPOs support any of these items. I would like to control the 3 inverters for my CCFLs on separate gpos as they are different colours.

But, can i wire two inverters onto one GPO (spec of inverter below)
Can i wire all the standard case fans together onto one gpo?

Specifications of Inverter
Input Voltage = DC12V
Input Current = 0.6A
Output Voltage = 1.2KVrms
Light Current = 5mA
Frequency = 40+/-5
Load = 2 x 300mm CCFL


thanks

With Revision 1.4 there are only three high powered GPO's. Each GPO can handle up to 1000mA of current. You can connect more than one fan per GPO as long as you stay within the given limitations. With just three fans, you should be fine...Unfortunately low powered GPO's cannot handle any of these functions unless modified.

thanks miles!

so three inverters on the high powered gpos

how easily can the low powered gpos be modified to handle 12v 0.6A? Can you point me in the direction of a tutorial?

Check out this link...

http://www.lcdforums.com/forums/viewtopic.php?t=1036

Different display, same idea!!

Thanks miles i read that article.

whoa! anyone fancy making me one??

Im afraid im not that electronically minded as you can guess from my posts!

I might see if i can attempt it! nice tutorial though. Whats the worst that can happen? i suppose i could always buy a new MO display after i blow this one up!