Page 1 of 1
Temp probe probs
Posted: Mon Jan 19, 2004 8:24 pm
by QuikBMWkid
hey i hook up my temp probes, and it is recognizing them and all, but what exactly do i have to do to have it display on the mx2??
Posted: Tue Jan 20, 2004 1:21 am
by Mat-Moo
http://www.lcdc.cc/help/configuration.htm#amxx
Just select the varaible from the text selection -> "Advanced features information->Dallas 1-wire->..."
Posted: Thu Jan 22, 2004 3:20 am
by Johnny
you cheeky matrix orbital boys!
Posted: Thu Jan 22, 2004 11:03 am
by Henry
[quote="Johnny
Posted: Fri Jan 23, 2004 5:26 am
by Johnny
how did he set up a poll though??
i though you had to be a mod to do that?
huh???
Posted: Fri Jan 23, 2004 11:57 am
by QuikBMWkid
hey yea i did the dallas one wire, and it recognised the 2 probes i have, and then i started the orbital and there was no temp whatsoever, i even checked under screen builder and couldnt find the screen for it.... it said under dallas one wire i wouldnt have to do anything else, but it diddnt end up working even though it recognized them...... what do i do
Posted: Fri Jan 23, 2004 12:33 pm
by Mat-Moo
Once the wire is set up correctly in LCDC
http://www.lcdc.cc/help/configuration.htm#amxx then you should see "Advanced features inforamtion" in the screenbuilders text definition area.
Posted: Fri Feb 06, 2004 8:04 pm
by QuikBMWkid
nope dont see it, send me a screenshot plz
Posted: Sat Feb 07, 2004 3:20 am
by Mat-Moo
If you follow the link in my previous message it's the second screenshot down. Is says "The advanced MXx features only show once enabled" under it!