Page 1 of 1

snip snip

Posted: Fri Dec 19, 2003 2:44 pm
by zander
I realise it may not be advisable (at all) but if it all goes well would there be any problem in triming the PCB slightly?!

It's one of the older 2 line USB displays and if possible I'd like to take off a bit of the bottom pcb (when lying face down) on the left hand side (uder the GPOs). It looks ok as the blobby bits marked r9 and r10 don't seem to go anywhere.... just double checking.

Oh and if you want to know it's as I put a switch in the wrong place in a custom case!...... yes I know i'm an idiot!!! :-s

Posted: Fri Dec 19, 2003 3:18 pm
by Miles
Hello...

What is the part number and what revision is the PCB?

Posted: Fri Dec 19, 2003 3:26 pm
by zander
LK202-25-USB Revision 1

Cheers!

Posted: Tue Dec 23, 2003 10:23 am
by Miles
Of course I can't encourage any PCB modifiations, but if you do decide to go ahead your warranty will be void!!

Posted: Wed Dec 24, 2003 8:07 am
by zander
I understand that! Just wanted to check that nothing vital crosses there and that it's possible if done with care!