Matrix Orbital Corp

Posted: **Wed Dec 17, 2003 10:43 am**

Is it possible to connect two fans like paspt fans or s2 noiseblocker fans with an Y onto one fan advanced gpo without any risk ?

Thx

Posted: **Wed Dec 17, 2003 12:40 pm**

The current rating per high powered GPO is 1 Amp. If the two fans combined power consumption does not exceed this limit. you should have no problem!! Be advised is you have more than 1 fan per GPO than you will not be able to read RPM...

Posted: **Wed Dec 17, 2003 4:52 pm**

and if the two fans consumption exceed this limit what can be the consequences ?
why I will not be able to read RPM ?

thx

Posted: **Wed Dec 17, 2003 8:24 pm**

You should not have any problem with more than one case fan on a GPO. Just add up the current for each fan and check that you are below 1.0A. I am running three 80mm case fans rated at 0.15A on one GPO. You also can read the RPM of one fan as long as you run the RPM signal from only that one fan back to the GPO.

Posted: **Wed Dec 17, 2003 8:34 pm**

I run 2 80mm fans off one GPO, the LED fans we sell... heck you could do like 7 of them on one GPO.. LOL

Posted: **Thu Dec 18, 2003 12:34 am**

ok I think it's will be ok so !

Thank You

Posted: **Fri Dec 19, 2003 3:19 pm**

Good to GO!!!

Matrix Orbital Corp

Fan connection on a LK202-24-USB rev1.4

Fan connection on a LK202-24-USB rev1.4