Page 1 of 1
How do I mount the Temp Probes?
Posted: Wed Nov 26, 2003 4:51 pm
by jlhinrichs
What is the best way to mount the temp probes? I would like to mount them so their removeable and not perminately glued or fastened. I wanted to mount one to my ram, one to one of my harddrives, etc.. I was thinking maybe ATV silicon or something like that. I also have QuickSilver epoxy adhesive but that's pretty perminate.
Any ideas???
Jay
Re: How do I mount the Temp Probes?
Posted: Thu Nov 27, 2003 1:25 am
by Henry
jlhinrichs wrote:What is the best way to mount the temp probes? I would like to mount them so their removeable and not perminately glued or fastened. I wanted to mount one to my ram, one to one of my harddrives, etc.. I was thinking maybe ATV silicon or something like that. I also have QuickSilver epoxy adhesive but that's pretty perminate.
Any ideas???
Jay
I used electrical tape... duct tape would work fine too...
Posted: Fri Jan 16, 2004 4:06 am
by Johnny
I would use 'heat proven tape'
Im sure electrical wouldnt melt but the glue on it can turn to a sticky goop at higher temps