Page 1 of 1
How to install case fans to MX212?
Posted: Wed Sep 17, 2003 9:41 pm
by SeRi@lDiE
Ok do I need any modification to install a few fans to my MX212?
Also where do I install them at?
Thanks
Posted: Thu Sep 18, 2003 12:27 pm
by Miles
Hello...
Please refer to the following link for a pic describing the available pinouts. The only mod needed is to ensure the high powered GPO jumper is in the appropriate setting. It should be set from the factory...
http://www.lcdforums.com/forums/viewtopic.php?t=1421
Posted: Thu Sep 18, 2003 12:46 pm
by SeRi@lDiE
Posted: Thu Sep 18, 2003 12:49 pm
by Miles
Are you sure the PCB revision is 1.2....????
Posted: Thu Sep 18, 2003 12:52 pm
by SeRi@lDiE
When I look in the back it does not display a version...
So I whent to FrozenCPU.com and in there description the stated version 1.2
Matrix Orbital v1.2 displays are the finest custom LCDs on the market . This is a 20 character x 2 line model that fits into a single 5"1/4 bay with a surrounding black bezel and keypad. This model uses a single USB cable for data and power, so is very simple to install
Posted: Thu Sep 18, 2003 12:54 pm
by Miles
Can you check below your USB cable for version type...?
Posted: Thu Sep 18, 2003 1:02 pm
by SeRi@lDiE
Rev 1.0
Posted: Thu Sep 18, 2003 1:22 pm
by Miles
You still can connect fans to GPO's 4,5,and 6. Please refer to the manual under the General Purpose Output section for instructions.
Posted: Sun Sep 21, 2003 3:15 pm
by SeRi@lDiE
I have a 3 PIN Fan Can I still do these even though the Panel is a 2 Pin?
Thanks a Lot in advance
Posted: Mon Sep 22, 2003 9:24 am
by Miles
You still can use the fan...be sure to connect power (red) and ground (black) appropriately...!!
Posted: Mon Sep 22, 2003 9:28 am
by SeRi@lDiE
Thanks Miles
Posted: Mon Sep 22, 2003 10:09 am
by Miles
no problem...anything else, let me know!
