Matrix Orbital Corp

I write here in the forum my question because via email I can't write you for a no relay problem on your mail server.


I see in LK204-25PC manual, in paragraph 6.1.11, that is possible to set the RS232 port speed of the display. I tried with LK204-25 but it does not work. There is a method to do this also with LK204-25 ?

Furthermore if I use the command in 6.1.11 to set to 9600 but I have the jumper set for 19200 (J3=out, J2=J1=in, J0=out), what happens ?

Waiting for your kindly response, best regards,

Carlo Allegretti
Multimodo S.r.l.



-----Messaggio originale-----
Da: Carlo Allegretti
Inviato: marted

Hello...

Perhaps you can provide me with your email address and I can contact you as we block various email accounts such as hotmail, excite, etc. Can you give me the exact part number of the module in question?