Page 1 of 1
2 pin probes?
Posted: Wed Jul 30, 2003 1:50 am
by thorilan
i have temp sensors that only have 2 connectors . will i be able to use them on the MX213 ? if so which pins do i connect .
any help wouldbe greatly apriciated
Posted: Wed Jul 30, 2003 10:00 am
by Paradigm
I'm assuming that you have a temperature diode (only 2 pins). Unfortunately they require hardware to bias them properly and do analog to digital conversions. The MX series does not have the hardware to use them. If you want a list of hardware that is available for the 1-Wire bus see
http://www.maxim-ic.com/1-Wire.cfm
Posted: Wed Jul 30, 2003 10:38 am
by thorilan
great .thank you very much . unfortunately it looks like if i cant find them localy here in japan ill have to order them and the shipping will cost more than buying 10 of them lol
Posted: Wed Jul 30, 2003 10:49 am
by Henry
We will be sleeing the temp probes in the next day or two, the cost will be $9.99 each and $some price if you buy 3 at a time...
Posted: Mon Aug 04, 2003 5:08 pm
by calvin166
hey, i bought a mx 212 about 6 months ago. i was reading modthebox's reveiw and it seemed as thoguh you have redone the mx212. can i hook up the new led's and temp probes to my old mx212?
Posted: Tue Aug 05, 2003 11:40 am
by Miles
No...the new MX2 has been modified and improved upon both firmware and hardware wise...
Posted: Tue Aug 12, 2003 10:17 pm
by calvin166
so neither the temp nor the leds.... that sucks
is it possible you will mak ones for the old mx 212?
Posted: Wed Aug 13, 2003 9:27 am
by Miles
The one wire device is not supported with the old MX222 therefore there is no way we can make it compatible. As for the LED Indicator, the pin-out does not match up.
Posted: Sun Aug 17, 2003 5:25 pm
by calvin166
darn...
i wish it was possible :|