Page 1 of 1
Additional Hard Drives
Posted: Fri Jun 27, 2003 11:03 pm
by Talamakara
Good Evening Everyone.
Two months ago i built a new computer and put an MX222.
These are the best little toys out there. But I have hit a road block and i was wondering if anyone out there has run into this little problem.
I have 2 IDE and 2 IDE/RAID ports on my computer. LCDC only detects my two hard drives that are on the IDE port and my two cd-roms, but it won't detect any of my other hds. Has anyone heard of this before?
Posted: Sat Jun 28, 2003 1:32 am
by Mat-Moo
LCDC only shows by C and D in the screen cycle, just add a new screen and add your own information. If you are already trying this but can't see it in the "Text Defintiion" screen (I only show c-f on that screen but you can access any disk) and enter the disk var, e.g.[#$SysDisTFRF] then just change the last letter to show what you want, so that var is for drive F.
Additional Hard Drives
Posted: Sat Jun 28, 2003 2:26 am
by Talamakara
Worked like a charm, thank you very much,
now i hope setting up MBM is that easy